fbpx
18.8 C
Sydney
Friday, March 29, 2024

Buy now

  • HID
  • HikVision ANPR
  • ID500014-HID-INTERCOM-26.02.2024-728x90
HomeFeaturedReject Security Panel Resistors

Reject Security Panel Resistors

Why you shouldn’t use resistors that come with security panels.

Why you shouldn’t use resistors that come with security panels.

Reject Security Panel Resistors

Reject security panel resistors – End of line (EOL) resistor circuits are one of the basic building blocks of security and access control systems. Field devices such as reed switches, duress buttons, motion sensors and locks all use EOL circuits to tell the security panel device state and help to ensure the cable serving each device is kept secure.

However, EOL resistors that come free with every security panel add a major vulnerability to security systems. These resistors, supplied on tape, are called axial resistors and are designed to be soldered, with strain relief, to a printed circuit board. They were never designed or intended to be used in the field connected directly to cable or security devices.

Why should installers reject security panel resistors? Axial resistor leads are made from brittle solid copper. They often can’t withstand even minor strain placed on them when terminated, then folded or pushed into a tight door frame, cable duct or wall cavity.

Every security technician has broken EOL resistors and has found broken resistors during service calls. Poor terminations, including broken resistors, are one of the leading causes of security system service call outs and security device down time.

Building EOL resistors circuits in the field using axial resistors is also fiddly, time consuming and makes up a large component of labour costs when installing new security devices. One incorrectly made or broken resistor network can take a lot of time to find and repair, which quickly erodes profit margin.

Reject Security Panel Resistors

Pre-built EOL resistor packs and devices with built in EOL resistors are widely available in the modern security market. These off-the-shelf solutions eliminate broken resistors and reduce termination errors. Throwing out the axial resistors in preference for a ready-made solution will save installers labour costs and security system owners many headaches.

If you choose to reject security panel resistors, the ATMOD quick connect, pre-built EOL resistor packs to suit most popular security and access control panels are available from Jack Fuse. You can request a sample here.

More new products from SEN.

AUTHOR

SEN News
SEN Newshttps://sen.news
Security & Electronics Networks - Leading the Security Industry with News and Latest Events. Providing information and pre-release updates on the latest tech and bringing it all to you daily. SEN News has been in print for over 20 years and has grown strong as a worldwide resource in digital media.

3 COMMENTS

  1. Half of the information provided is based on incorrect assumptions; Coper is not brital by nature it’s exact opposite. There are many reasons why EOL is required and it must be used. This article is written from a lazy technicians perspective.

    • Indeed, copper is in fact malleable, especially when formed into strands, such as in security cables. The point of this article is that leaded axial resistors are not suitable and were never designed for field installation such as we see them used in security systems.

      Any technican with any experience will attest to the brittle nature of traditional resistors.

      EOL networks are of course vital. No one is suggesting we shouldn’t use EOL supervision, there are just much better alternatives to traditional axial resistors available in the market today.

LEAVE A REPLY

Please enter your comment!
Please enter your name here

Related Articles

TODAYS WEATHER

18.8 C
Sydney
16 C
Canberra
28.5 C
Darwin
12.3 C
Hobart
18.4 C
Perth
18.9 C
Brisbane
15.1 C
Auckland
25.7 C
Melbourne

RECOMMENDED

- Advertisement -

POLL

RECOMMENDED